NUC8i7HNK下ubuntu16.04LTS安装realsense

安装环境

机型：Intel NUC8i7HNK 迷你电脑

操作系统：ubuntu16.04LTS

内核：4.15.0-47 -generic

安装操作指南

https://github.com/IntelRealSense/librealsense/blob/master/doc/distribution_linux.md

安装问题描述

安装文档中Installing the packages依次安装，安装运行到“sudo apt-get install librealsense2-dkms”时候会跳出Configuring Secure Boot的窗口，要求设置Secure Boot signing keys。如果忽略不管，或者设置密码后不管，会出现安装不成功的结果，导致“realsense-viewer”无任何连接信息！

问题解决

In order to make DKMS work, Secure Boot signing keys for the system must be imported in the system firmware, otherwise Secure Boot needs to be disabled. There are several methods to configure your system to properly load DKMS modules with Secure Boot enabled.

• Method 1 - Install the DKMS package you need

• Method 2 - Disable Secure Boot in shim-signed

• Method 3 - Disable Secure Boot from BIOS

1. Enter BIOS setup
2. Disable secure boot
3. Save configuration
4. Reboot the system

采用第三种方法，BIOS中Disable Secure Boot，重启机器，重新安装librealsense2-dkms和librealsense2-utils即可，运行realsense-viewer to verify the installation

其他问题

Intel NUC8i7HNK 迷你电脑安装Ubuntu16.04 LTS后，会出现安装后GUI不显示的情况。
解决方法有2个，
1.BIOS将Performance> Graphics> Intel iGD设置为Disable
2.BIOS将Performance> Graphics> Intel iGD设置为Enable
编辑/ etc / default / grub
GRUB_CMDLINE_LINUX_DEFAULT=“quiet splash nomodeset”
使用sudo update-grub更新

参考:
https://wiki.ubuntu.com/UEFI/SecureBoot/DKMS